Raditeq always tries to improve the EMC/RF branch and will report on this and other newsworthy information to you on this page.
RadiMation is used by hundreds of end-users worldwide, including many ISO 17025-accredited laboratories for EMC measurements. RadiMation has built-in protection and data integrity measures to
The latest EN 61000-4-3 standard describes two methods to perform a “field homogeneity verification” (also called ‘Uniform Field Area calculation’) (the constant field method and
The excel exporter does not work for the multiband test because it is impossible to produce a correct table for the information from all the
The RadiSwitch plug-in cards use high-quality RF relays with very low insertion loss and high isolation. The following maximum insertion loss and minimum isolation specifications
The internal relays can’t be used for handling RF power that is higher than the maximum power specification. For applications that requires switching of a
The General Motors EMC standard GMW3097 Appendix B describes ‘field calibration for ALSE procedure (RI – 1200 MHz to 1400 MHz at 300 V/m). The
Yes, the RadiPower model RPR2018C can be directly connected and controlled from a Windows PC through the USB interface in combination with RadiMation Freeware. All
Yes, the RadiPower model RPR3006W is a full compliant measuring device for conductive power measurements on the antenna ports of Wi-Fi devices in accordance to
This is a common problem with signal generators using step attenuators at the output stage. During changing of the RF carrier level, these step attenuators
The Ford FMC1278 standard requires pulse modulation using a packet of 50 pulses every second with a pulse duration of 3 µs and a pulse
When installing the RadiField for the first time or after any disconnect it might be that the internal polarizer motor of the RadiTower has “forgotten”
The RadiField is operated through the power supply and communication plug-in card (model PSU2400A). This plug-in card is installed in the RadiCentre (Pro) modular test
The IEC61000-4-3- standard defines that the harmonics generated by the amplifier shall be such that any measured field strength in the UFA at each harmonic
The RadiField is specified to generate a maximum field strength of 18 V/m at a test distance of 3 meters over a frequency range from
For its operation, the RadiField only needs a single RF coaxial cable. This coaxial cable should be suitable for frequencies up to 6 GHz (for
The firmware update for the RadiCentre® can be found here: www.raditeq.com/softwareupdate On this page you can also find the Installation guide to help you perform
The RadiSense probe is always measuring in rectangular coordinates, since all three axis’ are orthogonally aligned. In theory it does not matter how the sensor
The RadiCentre® (Pro) uses a hardware interlock plug (6,3mm ¼” stereo jack) which can be used as a safety interlock. The hardware interlock plug provides
